Denver, Colorado Springs & Aurora Combined Dry Pipe & Pre Action Systems
Using a combined dry pipe and pre action fire protection involves installation of the following fire protection components, exterior water supply main, penetration fire stopping, fire detection and alarm systems, fire protection general requirements, and fire pump systems. The combined dry pipe and pre action system uses multiple components to extinguish the fire. The fire detection alarms initiate the automatic fire sprinkler heads, where pressurized water then sprays unto the specific area for containment and to extinguish the fire.
Combined Dry Pipe & Preaction Applications
Combined systems are often installed where the temperature will drop below freezing range. Combined dry pipe and preaction systems are also present where water disbursed from a water based fire sprinkler system may damage computers, data centers, museums, clean rooms and labs. Clean agent fire suppression systems use dry chemicals or gases to extinguish fires and therefore eliminate the need for water discharge.
Denver, Colorado Springs & Aurora Combined Dry Pipe and Pre Action Tests & Inspections
NFPA 13D has created a standard for the installation of fire sprinkler systems, detailing information for the combined dry pipe and pre action system. “1.1” Scope. 1.1.1 This standard shall cover the design, installation, and maintenance of automatic sprinkler systems for protection against the fire hazards in one and two-family dwellings and manufactured homes. 1.1.2 This standard assumes that the sprinkler system is designed to protect against a fire originating from a single ignition location.”
 |
|
|---|---|
| Denver, Colorado Springs & Aurora Fire Prevention and Safety | Phone: (303) 578-6033 |
| Email: denverfirepro@gmail.com | Denver, Colorado Springs & Aurora Fire Sprinklers Denver, Colorado Springs & Aurora Fire Protection Service |
Emergency Fire Protection
Service Available
Install, Service & Repair
|
 |
 |
 |
No comments:
Post a Comment